![]() ![]() If power and air are on and correct.and consumables are in the torch it should fire. ![]() Well.first thing I would do is to jumper the input start on the Powermax45 (you said you were using a machine torch, not a hand torch).this is done on pins 3 and 4 of the CPC interface connector on the rear panel of the PMX45. Hopefully that will give you a bit more info. He also had someone else there when I turned up(he didn't think someone would travel 26000 kilometres to see him). He is only a 1 man band and he was very "stand-offish" towards me. I went to the USA for holidays back in early August and went to see the guy at Camcut. Need to get a post processor made by Bobcad to recognise Camcut machine. Doesn't give a lot of info out on his machines. The plans he sent were hard to understand. ![]() He supplied auto cad with his machine which has stepper motors etc. I use Bobcad software (which have been really good to me with info etc. The build time was 3 weeks.I ended up getting the machine at the end of September. Sorry Jim but that boat has already sailed.I have had trouble with him from the day I ordered my machine(13 March 2014) and it is still not running. You also could probably get the best help from your machine supplier (CamCut) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |